Hi guys,
Now, I finished my rear wheel as well. I would like to give you some feedback on the procedure, and on the TruSpoke tool.
So I started this project with the spoke wheels because I wanted these on my K100RS rebuild project. For this I bought a set of R1100GS wheels because the hubs fit the K100. Unfortunately the rims were bad, so I had to search for another solution. After a long search and a bit of luck I was presented an almost new set of R1250GS wheels at my local BMW dealer. The wheels were checked for being straight, which they were.
I had both the rims and old hubs sandblasted and Cerakoted (perfect finish). Then I started the trueing process. As I mentioned earlier the front wheel was finished quite quickly with a runout of less than 0.7mm.
I was less lucky with the rear one. I needed 3 attempts to get the wheel trued. I had a well visible “dent” radially, and axially. I tried a second time to true it, but with the same result. So I thought the process through and was fairly sure that the problem was the uneven lengths of the spokes. The spokes for the front wheel had also differences in length, but only minor (0.1mm at max). The ones for the rear wheel had 0.6mm difference between de longest and shortest ones, with the major part in between. So I grinded off the required material to get all spokes to the same length (a few spokes are now 0.1mm shorter). Then I double checked that the rim was straight, by putting it on a real flat surface, like a glass table. Using feeler gauges I could determine that the rim had a spot where it was 0.08mm ‘out of line’. With this I started a new trueing process, and the result was a runout of 0.3mm axially and 0.2mm radially.
In the end I’m convinced that when you can start trueing with perfect rims, good hubs, and spokes all with the exact same length, and with your instructions video, anyone can get these rims perfectly trued. I’m also sure that you will be able to get the wheels straight with less good material, but it will take much more effort and time.
About the TruSpoke tool: It’s a blessing to have it. However, as you state it is a sensitive tool. As you’re busy measuring, it is very hard to get a good reading as the needle may slip a little over the end of the spoke, because I guess the Torx bit has some play in the nipple. On a certain nipple you may measure a value, and on a second measuring you’ll be off by 0.2mm. Nevertheless, a great tool!
I can now proceed with my build. I expect it to be finished in Spring as I’m unable to work on it every day. (I’ll send some pictures).
Many thanks for making this great tool, and for all the help.
Best regards,
Bart.


Dear Bart,
Thank you so much for your sharing a detailed experience and for the kind words.
It really means a lot to our team to know that even though there is always room for improvements, the tool is doing what it is designed to do.
The run out results especially of the rear wheel are really impressive.
Good luck finishing the project and please keep in mind that we are here to help in any way we can.
Kind Regards,
Skylar Tools Customer Service